Clap switch using Arduino

Components and supplies



Male/Female Jumper Wires
Plastic Enclosure, Project Box
Relay Module (Generic)
5volt smps
Arduino UNO
digital sound sensor

Comments

Post a Comment

Popular posts from this blog

Blink LED

Blink LED simple codes You will need: LED Jumper cables Uno Board USB cable // Define the LED pin const int ledPin = 12; // LED connected to digital pin 12 void setup() { // Set the LED pin as an output pinMode(ledPin, OUTPUT); } void loop() { // Turn the LED on digitalWrite(ledPin, HIGH); // Wait for one second (2000 milliseconds) delay(1000); // Turn the LED off digitalWrite(ledPin, LOW); // Wait for one second (2000 milliseconds) delay(2000); }
Read more

Ultra Sonic Sensor with one LED

Bread board Ultra sonic sensor Jumper wire Arduino uno board USB cable // constants won't change const int TRIG_PIN = 6; // Arduino pin connected to Ultrasonic Sensor's TRIG pin const int ECHO_PIN = 7; // Arduino pin connected to Ultrasonic Sensor's ECHO pin const int LED_PIN = 3; // Arduino pin connected to LED's pin const int DISTANCE_THRESHOLD = 50; // centimeters // variables will change: float duration_us, distance_cm; void setup() { Serial.begin (9600); // initialize serial port pinMode(TRIG_PIN, OUTPUT); // set arduino pin to output mode pinMode(ECHO_PIN, INPUT); // set arduino pin to input mode pinMode(LED_PIN, OUTPUT); // set arduino pin to output mode } void loop() { // generate 10-microsecond pulse to TRIG pin digitalWrite(TRIG_PIN, HIGH); delayMicroseconds(10); digitalWrite(TRIG_PIN, LOW); // measure duration of pulse from ECHO pin duration_us = pulseIn(ECHO_PIN, HIGH); // calculate the distance distance_cm = 0.017 * dur...
Read more